Integrated Power Supply for TFT-LCD Panels with 6-Channel White LED Driver CXLC8986 CXLC8987 includes a high-performance boost regulator, 6-channel LED driver, a low dropout linear regulator (LDO)

   产品概述 返回TOPBZJ嘉泰姆

The CXLC8986 CXLC8987 includes a high-performance boost regulator, 6-channel LED driver, a low dropout linear regulator (LDO), a gate pulse modulator (GPM), a voltage detector, a VCOM buffer (unity-gain OPA), and a VGL linear regulator for active-matrix thin-film transistor (TFT) liquid-crystal displays (LCDs). The boost converter provides the regulated supply voltage for the panel source driver ICs. The converter is a high switching frequency (1.2MHz) current-mode regulator with an integrated 20V N-Channel 0.2Ω MOSFET that allows the use of ultra-small inductors and ceramic capacitors. It provides fast transient response to pulsed loading while achieving efficiency over 90%. The device can produce output voltage as high as 15V from an input as low as 2.8V. Soft-Start is programmed by external capacitor, which sets the input-current ramp-rate. The LED driver automatically regulated supply voltage for the LED light bars without the need to calculate the output for different LED types. It also integrates a 40V n-channel MOSFET that provides high output power. The 6-channel current driver is ideal for constant current driving, and, well matched less than 3%. To set the maximum driving current, the ISET pin is used to determine reference current. Each channel of the current drivers is set to 800 times of this reference current. A PWM pin can be used to perform PWM dimming from the range of 100Hz to 25kHz. The MODE pin in CXLC8986 CXLC8987 is used to set the dimming mode. If MODE pin set to VCC or floating, the dimming mode is in the PWM mode, the current driver ON/OFF is synchronized with the PWMB signal. If Mode pin set to GND, PWMB and ILED current is set at PWMB duty multiplied by ISET current when PWMB duty ≥ 25%. If the PWMB duty <25%, the ILED current is fixed at 0.25xISET, and the dimming duty is 4 x PWMB duty. Open LED-string automatically disable the channel from entering over voltage protection. The low-dropout (LDO) linear regulator can supply up to 350mA current while input voltage is 3.3V. It uses an internal PMOS as the pass device. It is suitable for the supply voltage of the timing controller. The GPM is controlled by frame signals from timing controller to modulate the Gate-On voltage, VGHM, which acts a flicker compensation circuit to reduce the coupling effect between gate lines and pixels. It also can delay the Gate-On voltage by the internal timer (60ms) while power-on for achieving a corrected power-on sequence for gate driver ICs. The falling time of the Gate-On voltage is programmable by external capacitor and resistor. The voltage detector monitors the supply voltage to issue a reset signal while the detected voltage is too low. The detecting level is decided by an external resistor divider and the delay time is programmable by an external capacitor. The VCOM buffer can drive the LCD VCOM voltage that features high short-circuit current (200mA), fast slew rate (12V/μs), wide bandwidth (12MHz) and rail-to-rail input/output. The gate-off linear regulator controller provides regulated TFT gate-off supplies using external charge pump attached to the switching node. Using the gate-low regulator after the produced negative voltage can regulate the exceeded voltage.

   产品特点 返回TOPBZJ嘉泰姆

„ 2.5V to 5.5V Input Supply Range BZJ嘉泰姆

„ Boost Regulator BZJ嘉泰姆

Š 1.2MHz Fixed Frequency BZJ嘉泰姆

Š Current-Mode Control BZJ嘉泰姆

Š Fast Transient Response to Pulse Load BZJ嘉泰姆

Š ±1% Accurate Output Voltage BZJ嘉泰姆

Š Built-In 20V/2A, 0.2Ω N-Channel MOSFET BZJ嘉泰姆

Š High Efficiency up to 90% BZJ嘉泰姆

Š Programmable Soft-Start BZJ嘉泰姆

Š Over-Current Protection BZJ嘉泰姆

Š Output Under-Voltage Protection BZJ嘉泰姆

„ White-LED Driver BZJ嘉泰姆

Š Wide 4.2V to 24V Input Supply Range BZJ嘉泰姆

Š 1.2MHz Fixed Frequency BZJ嘉泰姆

Š High Efficiency up to 90% BZJ嘉泰姆

Š 40V/2A, 0.2Ω n-channel MOSFET BZJ嘉泰姆

Š Input Under-Voltage Protection BZJ嘉泰姆

Š Over Current Protection BZJ嘉泰姆

Š Over Voltage Protection BZJ嘉泰姆

Š Maximum Programmable LED Channel Current 30mA BZJ嘉泰姆

Š Current accuracy ±3% and current balance ±2% BZJ嘉泰姆

Š 100Hz~25kHz PWM Dimming BZJ嘉泰姆

Š Mixed mode and PWM Dimming method BZJ嘉泰姆

„ High-Performance Operational Amplifiers BZJ嘉泰姆

Š ±200mA Output Short-Circuit Current BZJ嘉泰姆

Š 12V/μs Slew Rate BZJ嘉泰姆

Š 12MHz, -3dB Bandwidth BZJ嘉泰姆

Š Rail-to-Rail Input and Output BZJ嘉泰姆

„ Low Dropout Voltage Linear Regulator BZJ嘉泰姆

Š 350mA Maximum Output Current BZJ嘉泰姆

Š Adjustable Output Voltage BZJ嘉泰姆

„ On-Chip GPM Controller BZJ嘉泰姆

Š Flicker Compensator BZJ嘉泰姆

Š Power-On Sequence Control BZJ嘉泰姆

„ Linear Regulator Controller for VGL BZJ嘉泰姆

„ Low Voltage Detector BZJ嘉泰姆

 Š Programmable Detecting Voltage and Delay Time BZJ嘉泰姆

„ Thermal Protection BZJ嘉泰姆

„ RoHs Compliant BZJ嘉泰姆

„ TQFN5X5-40 PackageBZJ嘉泰姆

   应用范围 返回TOPBZJ嘉泰姆

„ Notebook Computer Displays BZJ嘉泰姆

„ UMPCs BZJ嘉泰姆

„ LCD MonitorBZJ嘉泰姆

   技术规格书（产品PDF) 返回TOP BZJ嘉泰姆

     需要详细的PDF规格书请扫一扫微信联系我们，还可以获得免费样品以及技术支持</span>！</span>
BZJ嘉泰姆