CXSD62131两个独立的1.5MHz恒定频率电流模式和PWM降压转换器组成2.7V至5.5V输入电压

目录HMh嘉泰姆

1.产品概述                       2.产品特点HMh嘉泰姆
3.应用范围                       4.下载产品资料PDF文档 HMh嘉泰姆
5.产品封装图                     6.电路原理图                   HMh嘉泰姆
7.功能概述                        8.相关产品HMh嘉泰姆

一,产品概述(General Description)   HMh嘉泰姆

  The CXSD62131 CXSD62131A CXSD62131C consists of two independent 1.5MHz constant frequency, current mode, and PWM step-down converters. Each converter integrates a main switch with a synchronous rectifier for high efficiency without an external Schottky diode. The CXSD62131  is ideal for powering portable equipment that runs from a single cell Lithium Ion (Li+) battery. Each converter can supply 1A of load current from a 2.7V to 5.5V input voltage. The output voltage can be regulated as low as 0.6V. The CXSD62131 can also run at 100% duty cycle for low dropout applications.HMh嘉泰姆
二.产品特点(Features)HMh嘉泰姆

1A Output Current on Each ChannelHMh嘉泰姆
2.7V to 5.5V Input Voltage RangeHMh嘉泰姆
1.5MHz Constant Frequency OperationHMh嘉泰姆
Low Dropout Operation at 100% Duty CycleHMh嘉泰姆
Synchronous TopologyHMh嘉泰姆
0.6V Low Reference VoltageHMh嘉泰姆
Current Mode OperationHMh嘉泰姆
Over-Temperature ProtectionHMh嘉泰姆
Over-Current ProtectionHMh嘉泰姆
Up to 94% EfficiencyHMh嘉泰姆
Internally CompensatedHMh嘉泰姆
Lead Free and Green Devices AvailableHMh嘉泰姆
(RoHS Compliant)HMh嘉泰姆
三,应用范围 (Applications)HMh嘉泰姆

TV Tuner/BoxHMh嘉泰姆
Portable InstrumentHMh嘉泰姆
四.下载产品资料PDF文档 HMh嘉泰姆

需要详细的PDF规格书请扫一扫微信联系我们，还可以获得免费样品以及技术支持！HMh嘉泰姆

 HMh嘉泰姆

五,产品封装图 (Package)HMh嘉泰姆

HMh嘉泰姆

六.电路原理图HMh嘉泰姆

HMh嘉泰姆

七,功能概述HMh嘉泰姆

Main Control LoopHMh嘉泰姆
The CXSD62131 has dual independent constant frequency,current-mode PWM step-down converters. During nor-HMh嘉泰姆
mal operation, the internal P-channel power MOSFET is turned on each cycle when the oscillator sets an internalHMh嘉泰姆
RS latch and is turned off when an internal comparator (ICMP) resets the latch. The peak inductor current at whichHMh嘉泰姆
ICMP resets the RS latch is controlled by the voltage on the COMP, which is the output of the error amplifierHMh嘉泰姆
(EAMP). An external resistive divider connected between VOUT and ground allows the EAMP to receive an outputHMh嘉泰姆
feedback voltage VFB at FB pin. When the load current increases, it causes a slightly decrease in VFB associatedHMh嘉泰姆
with the 0.6V reference, which in turn causes the COMP voltage to increase until the average inductor currentHMh嘉泰姆
matches the new load current.HMh嘉泰姆
Soft-StartHMh嘉泰姆
Each channel in the CXSD62131 has a built-in soft-start to control the output voltage rise during start-up. During soft-start, an internal ramp, connected to the one of the posi- tive inputs of the error amplifier, raise up to replace the reference voltage (0.6V typical) until the ramp voltage reaches the reference voltage.HMh嘉泰姆
Short Circuit ProtectionHMh嘉泰姆
For each channel, when the output is shortened to the ground, the frequency of the oscillator will be reduced toHMh嘉泰姆
210kHz. This lower frequency allows the inductor current to safely discharge, thereby preventing current runaway.HMh嘉泰姆
The oscillator’s frequency will gradually increase to its designed rate when the feedback voltage on the FB againHMh嘉泰姆
approaches 0.6V.HMh嘉泰姆
Over-Temperature Protection (OTP) HMh嘉泰姆
For each channel, the over-temperature circuit limits the junction temperature of the CXSD62131. When the junctionHMh嘉泰姆
temperature exceeds 150oC, a thermal sensor turns off the power MOSFETs, allowing the channels to cool down.HMh嘉泰姆
The thermal sensor allows the converter to start a soft-start process and to regulate the output voltage againHMh嘉泰姆
after the junction temperature cools by 40ïC. The OTP is designed with a 40ïC hysteresis to lower the averageHMh嘉泰姆
Junction Temperature (TJ) during continuous thermal overload conditions, increasing the lifetime of the device.HMh嘉泰姆
 Enable/ShutdownHMh嘉泰姆
For each channel, driving EN to the ground places the channel in shutdown mode. When in shutdown, the inter-HMh嘉泰姆
nal power MOSFETs are turned off, all internal circuitry shuts down, and the quiescent supply current reduces toHMh嘉泰姆
1μA maximally.HMh嘉泰姆
Automoatic PFM/PWM mode SwitchHMh嘉泰姆
The CXSD62131 is a fixed frequency PWM peak current modulation control step-down converter. At light loads,HMh嘉泰姆
the CXSD62131 will automatically enter in pulse frequency modulation operation to reduce the dominant switchingHMh嘉泰姆
losses. In PFM operation, the inductor current may reach zero or reverse on each pulse. A zero current comparatorHMh嘉泰姆
turns off the N-channel synchronous MOSFET, forcing DCM (Discontinuous Current Mode) operation at lightHMh嘉泰姆
load. These controls get very low quiescent, help to main-tain high efficiency over the complete load range.HMh嘉泰姆
八,相关产品                       更多同类产品.......HMh嘉泰姆