6+1CH serial input motoCXMD3289 is a 6+1-channel H-Bridge motor drivers IC for the digital camera and so on. It has two micro-stepping drivers, two full-swing/constant voltage/constant current drivers

   产品概述 返回TOPyyE嘉泰姆

      CXMD3289 is a 6+1-channel H-Bridge motor drivers IC for the digital camera and so on. It has two micro-stepping drivers, two full-swing/constant voltage/constant current drivers. CXMD3289 can be operated in serial control mode or partial exterior control mode. When operating in partial exterior control mode, the mode of each CH is fixed by initial serial control setting. When operating in serial control mode, the mode of each driver can be setting by serial control.

   产品特点 返回TOPyyE嘉泰姆

„Build-in two micro-steps drive mode is possible from 2-2 phase stepper drive to maximum 256 resolution micro-steps. yyE嘉泰姆

„ Built in 2 full-swing/constant voltage/constant current drivers switched by serial control with brake function yyE嘉泰姆

„ Low on-resistance (1.2Ω, sum of on-resistance of upside and bottom side) yyE嘉泰姆

„ Output current：IOUT<=0.8A(max.) for each channel yyE嘉泰姆

„ Build-in thermal shutdown (TSD, 150°C) yyE嘉泰姆

„ All power supply systems (VCC, VM12, VM34, VM5, VM6) can be set up with an independent power supply yyE嘉泰姆

„ Power save mode corresponds by serial control setup yyE嘉泰姆

„ PI (photo interrupter drive) 3 channel built-in. yyE嘉泰姆

„ Small 40TQFN (5×5mm) is adopted yyE嘉泰姆

„ Build-in POR (power on reset).yyE嘉泰姆

   应用范围 返回TOPyyE嘉泰姆

„ Stepping motor driver/ DC motor driver motor driver for DSCyyE嘉泰姆

   技术规格书（产品PDF) 返回TOP yyE嘉泰姆

     需要详细的PDF规格书请扫一扫微信联系我们，还可以获得免费样品以及技术支持！yyE嘉泰姆