中文
English
CXAR41183便携式通讯设备设计的音频功率放大器负载为8Ω的扬声器上连续输出1.0 W的功率失真度(THD+N)控制在1%在3V电源电压及8Ω负载下输出350mW的功率单位增益下是稳定状态BTL组态能驱动大的容性负载
| 产品型号： | CXAR41183 |
| 产品类型： | 运算放大器 |
| 产品系列： | AB类音频功放电路 |
| 产品状态： | 量产 |
| 浏览次数： | 40 次 |
产品简介
• 工作电压 2.5-5.5V
• F=217Hz以及VDD=5V时 PSRR=65dB
• 关闭模式下消耗电流0.1uA
• 改进了POP以及click噪音抑制电路
• 不需要输出耦合电容以及其它应用网络或电容
• 热关闭保护
• 单位增益下是稳定状态
• 允许外部增益控制
• BTL组态能驱动大的容性负载
技术参数
| 输入电压范围 (VIN) | ≤ 2.5 ~ 5.5VV |
|---|---|
| 输出电流 (IOUT) | 18mAA |
| 封装类型 | MSOP-8,TDFN-8 |
| Topology | AB类音频功放电路 |
| Control method | THD +N @ 1KHz (%):0.15 |
| Quiescent current | 2.4 |
| Noise | 67 |
| Features | Speaker (Ω):8 |
| Application | No of Speaker Channel:1 |
| Slew rate | Speaker (W):1 |
产品详细介绍
目录
7.相关产品
产品概述 返回TOP
CXAR41183是一款针对便携式通讯设备设计的音频功率放大器。在电源电压5V时，CXAR41183能在负载为8Ω的扬声器上连续输出1.0 W的功率，同时失真度(THD+N)控制在1%以下，而在3V电源电压及8Ω负载下，它则能输出350mW的功率。CXAR41183仅需要很少外围器件就能提供高质量的音频，其功耗极小。当将SHUTDOWN pin脚位变成低电位时，芯片将进入低功耗关闭模式。CXAR41183 包含的pop以及click噪音抑制电路，可在芯片打开或关闭之时来抑制pop以及click噪音。为了实现最大的灵活性， CXAR41183提供外部增益设定，以及外部控制芯片打开和关闭时间（利用BYPASS CAP.)。CXAR41183采用MSOP-8，3 mm x 3mm DFN封装。The CXAR41183 is an audio power amplifier designed for portable communication device applications such as mobile phone applications. The CXAR41183 is capable of delivering 1.0W of continuous average power to an 8Ω BTL and with less than 1% distortion (THD+N) from a 5.0V power supply, and 350mW to a 8Ω BTL load from a 3V power supply. The CXAR41183 provides high quality audio while requiring few external components and minimal power consumption. It features a low-power shutdown mode, which is achieved by driving the pin with logic low. The CXAR41183 contains circuitry to prevent from ”pop and click” noise that would otherwise occur during turn-on and turn-off transitions. For maximum flexibility, the CXAR41183 provides an externally controlled gain (with resistors), as well as an externally controlled turn-on and turn-off times (with the bypass capacitor). The CXAR41183 is available in a MSOP-8 , 3mm×3mm DFN package.
产品特点 返回TOP
• 工作电压 2.5-5.5V
• F=217Hz以及VDD=5V时 PSRR=65dB
• 关闭模式下消耗电流0.1uA
• 改进了POP以及click噪音抑制电路
• 不需要输出耦合电容以及其它应用网络或电容
• 热关闭保护
• 单位增益下是稳定状态
• 允许外部增益控制
• BTL组态能驱动大的容性负载
• 符合RoHS规范及Pb-Free符合RoHS规范及Pb-Freez 2.5-5.5V operation
z 65dB PSRR at 217Hz, VDD=5V
z 0.1μA ultra low current shutdown mode
z Improved pop & click circuitry
z No output coupling capacitors, snubber networks or bootstrap capacitors required
z Thermal shutdown protection
z Unity-gain stable
z External gain configuration capability
z BTL output can drive capacitive loads
z RoHS compliant and 100% lead(Pb)-free
应用范围 返回TOP
• 移动电话
• PDA
• 便携式电子仪器
z Mobile Phones
z PDAs
z Portable electronic devices
技术规格书（产品PDF) 返回TOP
需要详细的PDF规格书请扫一扫微信联系我们，还可以获得免费样品以及技术支持！
产品封装图 返回TOP
a
电路原理图 返回TOP
相关芯片选择指南 返回TOP 更多同类产品......
|
音频放大器> AB类 |
||||||||||
|
Part Number |
remark |
Vin (V) |
Speaker (W) |
Speaker (Ω) |
Headphone |
No of Speaker Channel |
THD +N @ 1KHz (%) |
IQ (mA)(Typ) |
PSRR (dB) |
Package |
|
1 Watt Audio Power Amplifier |
2.5 ~ 5.5 |
1 |
8 |
N/A |
1 |
0.15 |
2.4 |
67 |
MSOP-8,TDFN-8 |
|
|
1.36-W Mono Fully Differential |
2.5 ~ 5.5 |
1.36 |
8 |
N/A |
1 |
0.1 |
4 |
80 |
MSOP-8,TDFN-8 |
|
|
2-W Stereo Audio Power Amplifier with Mute |
2.5 ~ 5.5 |
2 |
3 |
Yes |
2 |
0.4 |
8 |
58 |
TSSOP-24(FD) |
|
|
3W Mono Fully Differential |
2.5 ~ 5.5 |
3 |
3 |
N/A |
1 |
0.1 |
4 |
80 |
SOP-8(FD) |
|
用户评论