CXMD3295数码相机等的6通道H桥电机驱动芯片五个全摆/恒压驱动器和两个全摆/恒流驱动器串行控制模式或部分外部控制模式下操作每个通道的模式由初始串行控制设置固定

CXMD3295是一款用于数码相机等的6通道H桥电机驱动芯片。它有五个全摆/恒压驱动器和两个全摆/恒流驱动器。CXMD3295可以在串行控制模式或部分外部控制模式下操作。在部分外部控制模式下运行时，每个通道的模式由初始串行控制设置固定。在串行控制模式下工作时，可以通过串行控制设置每个驱动器的模式。
内置5个全摆/恒压驱动器，通过带制动功能的串行控制切换
内置2个恒流驱动器，用于快门或光圈
“低导通电阻（1.2Ω，上侧和下侧导通电阻之和）”，输出电流：Iout<=0.8A（最大值）
内置热关机（TSD，150°C）
·内置CC模式弱激励
·CH1/2、CH3/4和CH5/6对应于2-2相或1-2相的STM控制
·所有电源系统（VCC、VM12、VM34、VM5、VM6）都可以设置独立的电源
·节电模式对应于串行控制设置
·PI（光断续器驱动）3通道内置。

目录

1.产品概述       2.产品特点     

3.应用范围       4.技术规格书下载（PDF文档）

5.产品封装       6.电路原理图  

7.相关产品

   产品概述 返回TOP

---

       CXMD3295 is a 6-channel H-Bridge motor drivers IC for the digital camera and so on. It has five full-swing/constant voltage drivers and two full-swing/constant current drivers. CXMD3295 can be operated in serial control mode or partial exterior control mode. When operating in partial exterior control mode, the mode of each CH is fixed by initial serial control setting. When operating in serial control mode, the mode of each driver can be setting by serial control.

   产品特点 返回TOP

---

„ Built-in 5 full-swing/constant voltage drivers switched by serial control with brake function 

„ Built-in 2 constant current drivers for shutter or IRIS 

„ Low on-resistance (1.2Ω, sum of on-resistance of up side and bottom side) „ Output current：Iout<=0.8A(max.) for each channel 

„ Built-in thermal shutdown (TSD, 150°C) 

„ Built-in CC mode weak excitation 

„ CH1/2, CH3/4 and CH5/6 correspond to STM control of 2-2 phase or 1-2 phase 

„ All power supply systems (VCC, VM12, VM34, VM5, VM6) can be set up with an independent power supply 

„ Power save mode corresponds by serial control setup 

„ PI (photo interrupter drive) 3 channel built-in. 

„ Small 40TQFN (5×5mm) is adopted

   应用范围 返回TOP

---

„ Stepping motor driver/ DC motor driver for DSC

   技术规格书（产品PDF) 返回TOP 

---

     需要详细的PDF规格书请扫一扫微信联系我们，还可以获得免费样品以及技术支持！

 

产品封装图 返回TOP

---

电路原理图 返回TOP

---

a

相关芯片选择指南 返回TOP                      更多同类产品......

---

Motor Driver
Part NO.	VCC(V min.	VC(V max.	VM(V min.	VM(V max.	CH	Build -in PI	Exterior  Control	Serial Control	Note	Package
CXMD3289	2.9	6	2.9	5.5	6+1	3	Y CH5~6	Y	CH12&CH34 :Micro Stepping, CH5~CH6: CC/CV/FS	TQFN5X5-40
CXMD3290 /B	3	6	3	6	5+1	3	Y	Y	CH12:256-Step MicroStepping CH3~CH4: CV/FS,CH5:CC	TQFN4X4-28
CXMD3291	2.3	5	--	--	1	--	N	I2C	CC*1,High active, 10 bit DAC	TDFN2X2-6 WLCSP2X3-6
CXMD3292	2.5	5.5	--	--	1	--	Y	N	CC*1	SOT23-8 TDFN2X2-8
CXMD3293	1.5	6	2.9	6	5+1	3	Y	Y	CH1~3:CV/FS,CH5:CC/FS,CH4:CC /CV/FS,CC mode weak excitation	TQFN4X4-32
CXMD3294	1.8	5.5	--	--	1	--	Y	N	FS*1	WDFN1.6X1.4-6 SOP8/SOP8(FD)
CXMD3295	2.5	6	2.9	6	6+1	3	Y	Y	CH1~4,CH5:CV/FS,CH6:CC/FS, Built-in CC mode weak excitation	TQFN5X5-40
CXMD3296	2.5	5.5	3	5.5	4+2	3	Y	Y	CH1~3:CV/FS,CH4:CC/FS CH5:CV/FS	TQFN4X4-28
CXMD3297	2.5	6	2.9	6	4+2	3	Y	Y	CH1~3:CV/FS,CH4-4A: CC/CV/FS,CH4-4B:CC/FS	TQFN3X3-20
CXMD3298	2.2	5	1.8	10.5	1	0	Y	N	FS*1	DIP8/SOP8
CXMD3299	2.2	5	1.8	10.5	2	0	Y CH1~2	N	FS*2,2-Channel H-bridge drivers	DIP16/SOP16
CXMD32100	2.5	5	2.9	5	4+2	1	Y	Y	CH1~3:CV/FS,CH4:CC/FS CH5:CV/FS	TQFN3X3-20
CXMD32101	3	3.6	3	6	5+1	3	Y	Y	CH12:Micro_stepping, CH3~4 :CV/FS,CH5:CC/FS	TQFN4X4-32
CXMD32102	2	5	2	10.5	1	0	Y	N	FS*1	SOP8(FD) DIP-8
CXMD32103	3	5.5	3	5.5	8+1	2	Y	I2C	CH1~3&CH5~9:CV/FS, CH4:CC/CV/FS	TQFN5X5-40
CXMD32104	2.5	5	4	16	1	0	Y	N	HV FS*1	SOP8(FD) TSSOP14
CXMD32105	2.5	6	2.9	6	5+1	3	Y	Y	CH1~3:CV/FS,CH5:  CC/FS,CH4:CC/CV/FS	TQFN4X4-32
CXMD32106	2.5	6	2.9	6	5+1	2	Y	Y	CH1~3:CV/FS,CH5: CC/FS,CH4: CC/CV/FS with Chopper Control	TQFN4X4-44