目录0qp嘉泰姆

1.产品概述                       2.产品特点0qp嘉泰姆
3.应用范围                       4.下载产品资料PDF文档 0qp嘉泰姆
5.产品封装图                     6.电路原理图                   0qp嘉泰姆
7.功能概述                        8.相关产品0qp嘉泰姆

 0qp嘉泰姆

一,产品概述(General Description)         0qp嘉泰姆
   CXSU63039 is a high efficiency synchronous boost regulator that converts0qp嘉泰姆

down to 2.5V input and up to 5.5V output voltage. It adopts NMOS for the0qp嘉泰姆

main switch and PMOS for the synchronous switch. It can disconnect the 0qp嘉泰姆

output from input during the shutdown mode..0qp嘉泰姆

  It integrates 5A power MOSFET and can output 5V 2.5A with Li-Battery input.0qp嘉泰姆
二.产品特点(Features)0qp嘉泰姆
1.)2.5V Minimum input voltage0qp嘉泰姆
2.)Adjustable output voltage from 3V to 5.5V0qp嘉泰姆
3.)6A peak current limit0qp嘉泰姆
4.)Input under voltage lockout0qp嘉泰姆
5.)600Khz fixed Switching Frequency0qp嘉泰姆
6.)Load disconnect during shutdown0qp嘉泰姆
7.)Integrated soft-start0qp嘉泰姆
8.)Output over voltage protection0qp嘉泰姆
30moJTM Power MOSFET0qp嘉泰姆
Thermal Shutdown0qp嘉泰姆
QFN4x4-16 Package0qp嘉泰姆
三,应用范围 (Applications)0qp嘉泰姆
1.) Handheld Devices0qp嘉泰姆
2.)Power Bank0qp嘉泰姆
3.)All Single Cell Li or Dual Cell Battery Operated Products0qp嘉泰姆
四,产品封装图 (Package)0qp嘉泰姆
0qp嘉泰姆
0qp嘉泰姆

五,电路原理图0qp嘉泰姆
0qp嘉泰姆
0qp嘉泰姆
0qp嘉泰姆
六.产品PDF文档0qp嘉泰姆

需要详细的PDF规格书请扫一扫微信联系我们，还可以获得免费样品以及技术支持！0qp嘉泰姆

 0qp嘉泰姆

七,功能概述0qp嘉泰姆

SYNCHRONOUS RECTIFIER0qp嘉泰姆
The device integrates an N-channel and a P-channel MOSFET transistor to realize a0qp嘉泰姆
synchronous rectifier. Because the commonly used discrete Schottky rectifier is replaced with0qp嘉泰姆
a low RDS(ON) PMOS switch, the power conversion efficiency reaches 96%. To avoid0qp嘉泰姆
ground shift due to the high currents in the NMOS switch, two separate ground pins are used.0qp嘉泰姆
The reference for all control functions is the GND pin. The source of the NMOS switch is0qp嘉泰姆
connected to PGND. Both grounds must be connected on the PCB at only one point close to0qp嘉泰姆
the GND pin. A special circuit is applied to disconnect the load from the input during0qp嘉泰姆
shutdown of the converter. In conventional synchronous rectifier circuits, the backgate diode0qp嘉泰姆
of the high-side PMOS is forward biased in shutdown and allows current flowing from the0qp嘉泰姆
battery to the output. This device however uses a special circuit which takes the cathode of0qp嘉泰姆
the backgate diode of the high-side PMOS and disconnects it from the source when the0qp嘉泰姆
regulator is not enabled (EN = low).0qp嘉泰姆
The benefit of this feature for the system design engineer is that the battery is not depleted0qp嘉泰姆
during shutdown of the converter. No additional components have to be added to the design0qp嘉泰姆
to make sure that the battery is disconnected from the output of the converter.0qp嘉泰姆
八,相关产品           更多同类产品........    0qp嘉泰姆

0qp嘉泰姆